Please follow these steps to setup the camera to your wireless network:

1. Connect the camera to your router using an Ethernet cable. Also, use a 12v power supply to power the camera.
2. Once the camera is powered and connected to the network, use our SADP software to pick up the IP address. If you do not have the SADP software, you can download it here(Make sure to disable any anti-virus or malware protection software before SADP installation): here.

3. Once the camera is on the network it should show up on the SADP software. Make sure the IP address matches the network IP address of your network.

4. Log into the NVR and go to Camera>Camera>D# (camera channel)>Edit (Paper & pen): Adding Method-Manual-Enter camera IP information-OK.